Measure and mark a point 2 inches 5 1 cm away from each side of the removed segment.
Patch siding how remove nails top row.
You should be able to slide it horizontally and remove it from the channel to expose the nails from the second row down.
Cut the spare piece of vinyl along the marks using straight tin snips.
Score down the damaged lap siding with a utility knife.
Push the siding downward to remove it from the piece below it.
Hold the removed segment up to a spare piece of vinyl siding.
Place the palms of your hands on the siding and apply downward pressure until the piece pops free.
Remove the nails on the lap board then use the claw of the hammer to split the board down the center image 1.
Insert a pry bar between the piece of siding from which you want to remove the nails and the one above it.
After you remove the nails from the top of the piece of siding it is still hooked to the piece below it.
Remove the nails one at a time to disconnect the entire length of vinyl.
Start by lifting an overlapped piece of vinyl on the top row.
Cut a vinyl patch 4 inches 10 cm wider than the removed segment.
An oscillating tool with a metal cutting blade works great for this or you can use a mini hacksaw with the blade extended beyond the end of the holder.
Remove the nails in the corner cap.
Blind nail the fiber cement siding in place starting with the bottom piece.
Use a pry bar to remove the damaged siding.
In a pinch you can wrap duct tape around the bottom of a hacksaw blade to protect your hand and use it to cut through the nails.
Repeat until you re at the ground and then remove the surrounding trim.
Position the pry bar beside a nail and pry the upper board outward until the nail pops.