Experts say that if you are putting in a second layer of insulation you should have no vapor barrier between the two layers.
No vapor barrier in attic insulation.
Fiberglass insulation must stay dry to be effective.
The best approach for a vented attic in a cold climate is installing a layer of drywall with a good coat of latex paint the paint creates a semi permeable vapor barrier.
Vapor barriers are sheets of plastic or other material placed on one side of insulation sheets.
Vapor barrier up or down.
Then cover the foam with drywall as required for fire safety.
This barrier is meant to keep moisture from getting to the insulation in the walls and ceilings and it is required by building codes when insulating most houses.
So for this top layer you would be purchasing unfaced insulation batts not rolls of an r value of at least 30.
A vapor barrier in an attic assembly in a severely cold climate with the absence of an air barrier will likely be ineffective.
The insulation fiberglass or cellulose is then placed on top of the drywall with no vapor barrier above or below.
Before the introduction of attic insulation attics in cold climates were poorly insulated and plastic ceiling vapor barriers were omitted.
The paper facing contains a layer of impermeable asphalt that prevents water vapor from passing through it.
A vapor retarder is a material used to prevent water vapor from diffusing into the wall ceiling or floor during the cold winter.
On the other hand an air barrier a properly detailed air tight drywall ceiling for example in the absence of a vapor barrier can be effective since it stops the flow of vapor laden air.
Foam blocks airflow needs no vapor barrier and has a higher r value per inch than loose fill or batts so you ll get more protection with less depth.
With spray foam unlike with loose fill or batts you must cover the soffit vents they aren t needed to keep the roof cool.
Not every wall does.